Structural analysis

This tool determine the shear force, bending moment and deflection of a single-span beam with different types of applied loading. The calculators are for a simply supported beam or a cantilever beam.

This tool calculates he moment of inertia for an angle section about its centroidal axes as well as about its base. Enter the height, width and thickness of your section to get the results.

This tool determines the shear modulus, a measure of the elastic shear stiffness of a material. For isotropic materials, the shear modulus is directly proportional to Young's modulus with Poisson's ratio as a multiplier.

You can use this calculator to determine the depth to the neutral axis of a reinforced concrete section in three different stages of concrete cracking: uncracked linear-elastic section, cracked linear-elastic section, and cracked nonlinear elastic section. All calculations are conducted in accordance with AS 3600-2018.

This tool analyzes steel beams and columns under axial loads and uniaxial or biaxial bending. The result is a Stress Ratio, which compares the actual stress to the allowable stress. Calculations are based on the American Institute of Steel Construction's Specification for Structural Steel Buildings-Allowable Stress Design and Plastic Design, 1989.

Using this tool, you can visualize the shear force, bending moment, and deflection of a simply supported beam when a point load is applied at any point on the beam.

This template is used to analyze and design reinforced concrete beams. It considers applied axial, shear, and moments and checks all ULS and SLS load combinations. It checks the moment and shear capacities, deflections, as well as the minimum depth, cover, and reinforcement required based on ACI 318-19 and ASCE 7-22 standards.

This tool analyzes the capacities and utilization factors of IPE and HE steel sections. It takes into account the effects of bending, shear, and axial compression or tension on the sections. All calculations follow the guidelines established in EN 1993-1-1 (2005) - Design of steel structures - Part 1-1: General rules and rules for buildings.